Flex MS 1706 FR Instrucciones De Funcionamiento página 20

Note
When the power tool is switched off, the tool
continues running briefly.
6. Switch off the power tool.
7. Remove the remaining web with the
supplied web remover.
Swivelling the motor unit
To improve guiding the cut and handling,
the drive unit can be swivelled.
n Pull up the release handle (6) and swivel
the motor unit as far as it will go.
The release handle must engage in the
new position.
The user can now adopt an ergonomically
favourable posture when making a drawing
cut.
Operating instructions
To make vertical cuts, swivel the motor unit
as described previously.
Place the machine above and pull
downwards.
20
Your right hand guides the motor unit,
your left hand pulls on the handle (7).
To make horizontal cuts, push the power
tool.
Your right hand guides the motor unit, your
left hand is placed on the handle/intake
flange (4)
Tips
When making cuts in a very hard material,
the diamond cutting disc may overheat and
be damaged.
n Immediately stop cutting and leave the
cutting disc to cool down at no-load
speed.
A spark ring around the cutting disc and
a decreasing cutting rate are signs of a blunt
cutting disc.
Wall chaser MS 1706 FR