Search For Sensor; Clock And Calendar; Clock Reception - Oregon Scientific BAR989HG Manual De Usuario

--- shows in Temp /
Humidity Area

SEARCH FOR SENSOR

To search for a Thermo / Hygro sensor, press SELECT
to navigate to the Temperature / Humidity Area.
show next to the Area. Then, simultaneously press and
hold MEMORY and CHANNEL for 2 seconds.
To search for the UV sensor, press SELECT to navigate
to the UVI / Barometer Area.
Area. Then, press and hold MEMORY and CHANNEL for
2 seconds (the UV sensor is an optional item).
NOTE
If the sensor is still not found, check the
batteries.

CLOCK AND CALENDAR

This product tracks the time and date based on radio
signals from the remote sensor, or manual settings that
you enter.
BAR989HG_M_EN_op.p65
Sensor 1 is sending data.
(The number shows which
sensor is selected.)
The selected sensor
cannot be found.
Search for the sensor
or check batteries.
will
will show next to the
15

CLOCK RECEPTION

The time and date are automatically updated by radio
signals from official time-keeping organizations unless
you disable this feature. See the Remote Sensor section
for more information.
Initial reception takes 2-10 minutes, and is initiated when
you first set up the unit, and whenever you press RESET.
If the radio signal is weak, it can take up to 24 hours to
get a valid signal reception. Once complete, the reception
icon will stop blinking.
The icon shown in the Clock Area indicates
2 factors:
• Connection between the main unit and the sensor
that collects radio signals (
• Radio signal reception (
How these signals work together:
ICON MEANING
The unit has contact with the
sensor and has synchronized the
time.
The unit has contact with the
sensor but the time has not been
synchronized.
15
2005.9.17, 10:29 AM
)
)