Data Transmission; Search For Sensor; Clock - Oregon Scientific BAR888RA Manual Del Usuario

Place the sensor in a location with a clear view to
the sky, away from metallic or electronic objects.
Position the sensor close to the main unit during
cold winter months as below-freezing temperatures
may affect battery performance and signal
transmission.
You may need to experiment with various locations to
get the best results.

DATA TRANSMISSION

Data is sent from the sensor(s) every 40 seconds. The
reception icon shown in the Temperature Area shows
the status.
ICON DESCRIPTION
Main unit is searching for
sensors.
At least 1 Channel has been
found.
Channel 1 is selected
(number will change
depending on the sensor
you select).
--- shows in Outdoor The selected sensor cannot
Temp Area be found. Search for the
sensor or check batteries.

SEARCH FOR SENSOR

To search for a sensor, press and hold MEMORY and
CHANNEL for 2 seconds.
NOTE If the sensor is still not found, check the
batteries, obstructions, and remote unit loaction.
NOTE Signals from household devices such as
doorbells, electronic garage doors, and home security
systems may cause temporary reception failure. This is
normal and does not affect general product performance.
The reception will resume once the interference ends.

CLOCK

The main unit automatically synchronizes the current time
and date on the clock when it is brought within range of
the WWVB-60 atomic clock signal generated from Fort
Collins, Colorado. For more information, please visit: www.
boulder.nist.gov/timefreq.stations/radioclocks.htm. The
signals are collected by the main unit when it is within 932
miles (1500 km) of a signal.
Initial reception takes 2-10 minutes, and is initiated
when you first setup the unit, and whenever you press
RESET. Once complete, the reception icon will stop
blinking. The icon is shown in the Clock Area.
7