Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Component Reference and Brush Installation
TROUBLESHOOTING CHART
SYMPTOM
Pump stops without
warning
Pump Won't Prime
Pump leaks
Pump runs, pumps
little or no water
Brush Installation
1 2 3
MODEL SD106-01
COMPONENT REFERENCE
Key
No.
1
10-32x1-3/4 Phil. Hd Screw*
2
End Cover / Wear Plate
3
O-Ring
4
Impeller
5
Insert
6
U Cup Seal
7
Pump Body
8
Slinger
9
Motor**
10
Motor Brush and Spring Set (1 Pair)
* Standard hardware item; purchase locally.
** If motor fails, replace entire pump.
PROBABLE CAUSE(S)
Pump has overheated and thermal
overload has tripped
Discharge hose too long or
discharge lift higher than 28'
Pump body not oiled
Suction hose too long or
too small
Worn impeller
Suction leaks
Suction hose kinked or coiled
Shaft U-cup seal leaks
Cover O-Ring leaks
Worn impeller
Bad motor brushes
Bad U-cup shaft seal
(pump will leak)
Suction or discharge hose
kinked or coiled
4
5
6
7
Part
Description
CORRECTIVE ACTION
Wait for overload to reset; pump will
automatically restart
Use shorter hose or reduce lift
Add oil through inlet port (see Page 3)
"
Use 1/2
Suction hose, 25' long or less
(the shorter the hose, the better)
Replace impeller
Replace hose washer, check for leaks in hose
Straighten out suction hose
Replace shaft seal
Replace cover O-Ring
Replace impeller
Replace motor brushes
Replace shaft seal
Straighten out hose
8 9
10
Pump Head Assembly No. RP4940-22
includes Key Nos. 1 through 7.
Service Kit No. FP003414S-01
includes 1 each of Key Nos. 3, 4,
and 6.
Brush Kit No. FP003415S
includes a pair of replaceable brushes,
springs, and caps, Key No. 10.
Pud-L-Scoop
includes the Pud-L-Scoop
garden hose with washer.
Brush must enter
square hole.
Match brush curve
to armature curve
No. FP000349A
TM
, and a 6'
TM
6
Publicidad
Tabla de contenido
