Publicidad
INSTALLATION - INSTALLATION - INSTALACIÓN
fig. 11
red
Blue
5/8"
[16 mm]
Hot
Cold
siNK iNsTAllATiON
Beforeinstallationassembleonthemixerthecomplements:
- screw on the body the threaded stem until the mechanical stop;
- screw on the body the supply hoses paying attention not to damage tightness o-rings;
- screw on the pin inside the body the control rod of the drain orienting it properly;
- screw the knob to the threaded pin on the back of the mixer.
Putthesingle-handmixerontheholeofthesinkandpositiontheshapedgasketandtheflangeonthestud
bolt.Tightenupthetierodbyusinga7/16"[11mm]key.
DrAiN DeViCe iNsTAllATiON
Separate the lower pipe from the body of the device and remove the protection plug from the latter.
Install the drain device in the hole of the sink inserting the components in the indicated sequence and screwing
tightly the fastening nut.
Connectthecontrolrodtothelowerpipeofthedrainandthenjoinittothepopuprodofthespoutwiththe
clampjoint.
CONNeCTiONs
Connect supply hoses to the water network paying attention to interpose tightness gaskets.
Open the water network and check there are no leakages.
iNsTAllATiON Du lAVABO
Avantdeprocéderavecl'installationilfautassemblersurlemitigeurlesdifférentsaccessoires:
-visseraucorpslatigefiletéejusqu'àl'arrêtmécanique;
-visseraucorpslesflexiblesd'alimentationenveillantànepasabîmerlesjointstoriquesd'étanchéité;
-visseraupivotàl'intérieurducorpslatigedecommandedelavidangeenl'orientantcorrectement;
-visserlapoignéeaupivotfiletésurl'arrièredumitigeur.
Placerlemonocommandesurletroudel'évieretplacersurleboulonprisonnierlejointfaçonnéàlabride.
Serreràfondletirantenutilisantunecléde7/16"[11mm].
16
Publicidad
