RESQ RPX200 Manual De Instrucciones página 9

Note! Always verify lifting progress by looking at the rope colour threads movement in and out of the device.
6 . 6 B A S I C L I F T I N G - B O D Y M O U N T E D
1. Attach the rescue rope to an anchor point directly via the rope carabiner or with a anchor sling at least 1 meter above the
casualty.
2. Pull the device towards the casualty so you can attach it to the casualty's harness (upper attachment point)
3. Remove any slack between you and the device by pulling the trailing rope upwards.
4. Pull the trailing rope through the first friction loop into the rope groove of the brake housing, around the second friction loop,
insert the rope into the rope clamp and tighten.
5. Start to lift by turning the handwheel in clockwise direction with two hands. Frequently tighten the slack between the friction
loop and rope clamp. Approx. after every 10 turns on the handwheel.
Note! Secure if necessary the trailing rope around the device to eliminate the risk of unintentional descent.
6. Free the casualty from its fall arrest
7. Start the control descent by releasing the trailing rope from the rope clamp by pulling it downwards.
8 | v.1 | Master EN | RPX200 & EPX200 |
6.5.4
6.6.4
6.5.7