Electrical Safety - Black and Decker FEJ520J Manual De Instrucciones

Chargers
Your charger has been designed for a
specific voltage. Always check that the
mains voltage corresponds to the voltage
on the rating plate.
Warning! Never attempt to replace the
charger unit with a regular mains plug.
Use your BLACK+DECKER charger
u
only to charge the battery in the
appliance with which it was supplied.
Other batteries could burst, causing
personal injury and damage.
Never attempt to charge non-
u
rechargeable batteries.
If the supply cord is damaged, it must
u
be replaced by the manufacturer or an
authorised BLACK+DECKER Service
Centre in order to avoid a hazard.
Do not expose the charger to water.
u
Do not open the charger.
u
Do not probe the charger.
u
The appliance/battery must be
u
placed in a well ventilated area when
charging.

Electrical safety

Symbols on the charger
Read all of this manual carefully before using the
# appliance.
This tool is double insulated; therefore no earth wire
is required. Always check that the power supply
$
corresponds to the voltage on the rating plate.
The charging base is intended for indoor use only.
Labels on appliance
The following symbols appear on this appliance along with the
date code:
(Original instructions)
+
Read all of this manual carefully before
using the appliance
Only use with charger S010Q 23
S010Q 23
Features
This tool includes some or all of the following features.
1. On/off power switch
2. Handle
3. Nozzle
4. Pull out crevice tool
5. LED charging indicator
6. Dust bowl
7. Floor extension release clip
8. Floor extension tube
9. Floor head release clip
10. Flip down brush
11. Floor head
12. Charger
13. Charging port
Use
Switching on and off (Fig. A)
Press the button to turn on, the unit operates in slow
u
speed, low power mode, conserving the battery life.
Press the button again, and the unit goes to a BOOST
u
mode.
Pressing the button again will turn the product off.
u
Using the pull out crevice tool (Fig. B,C)
Extend the crevice tool (4) as shown in figure C, until it
u
clicks in place.
To retract the crevice tool (4) press the crevice tool release
u
button (4a) allowing it to return to its normal position
(Fig. B).
Fitting the floor extension tube (Fig. D)
Slide the nozzle (3) into the floor extension tube (8) until
u
you hear an audible 'click' as shown in figure D.
The floor extension tube is supplied with a flip down brush
u
(10) for cleaning difficult to reach areas (Fig.E).
Fitting the floor head (Fig. F)
Slide the floor extension tube (9) onto the floor head (11)
u
until you hear an audible 'click' as shown in figure F.
Removing and clearing hair from the beater
bars (Fig. G, H)
Depress the beater bar unit (13) release button (14) as
u
shown in figure G.
ENGLISH
7