Medisana 45062 Instrucciones De Manejo página 28

For ME EQUIPMENT and ME SYSTEMS that are not LIFE-SUPPORTING
Guidance and manufacturer's declaration - electromagnetic immunity
The AN-6019 is intended for use in the electromagnetic environment specified below. The customer
or the user of the AN-6019 should assure that it is used in such an environment.
IMMUNITY IEC 60601test
test
Radiated RF 3 V/m 80 MHz
IEC 61000-4-3 to 2.5 GHz
NOTE 1 At 80 MHz and 800 MHz, the higher frequency range applies.
NOTE 2 These guidelines may not apply in all situations. Electromagnetic propagation is affected by
absorption and reflection from structures, objects and people.
a Field strengths from fixed transmitters, such as base stations for radio (cellular/cordless) telephones
and land mobile radios, amateur radio, AM and FM radio broadcast and TV broadcast cannot be
predicted theoretically with accuracy. To assess the electromagnetic environment due to fixed RF
transmitters, an electromagnetic site survey should be considered. If the measured field strength in the
the location in which the AN-6019 is used exceeds the applicable RF compliance level above,
the AN-6019should be observed to verify normal operation. If abnormal performance is observed,
additional measures may be necessary, such as re-orienting or relocating the AN-6019.
b Over the frequency range 150 kHz to 80 MHz, field strengths should be less than [V1] V/m.
28
Compliance
level level
3 V/m
Table 3
Electromagnetic environment-guidance
Portable and mobile RF communications
equipment should be used no closer to any part
of the AN-6019, including cables, than the
recommended separation distance calculated
from the equation applicable to the frequency
of the transmitter.
Recommended separation distance：
80 MHz to 800 MHz
transmitter in watts (W) according to the
transmitter manufacturer and d is the
recommended separation distance in meters (m).
Field strengths from fixed RF transmitters, as
determined by an electromagnetic site
a
survey, should be less than the compliance
level in each frequency range.
Interference may occur in the vicinity
of equipment
Marked with the following symbol:
800 MHz to 2,5 GHz
Where P is the maximum
output power rating of the
b