Beninca RI.6E Libro De Instrucciones página 7

Off= Automatic re-closing enabled
On= Automatic re-closing disabled
DSW3 This enables or disables the apartment building function (after the first opening command, the
P.P. button and the Remote control are deactivated).
Off= Apartment building function disabled.
On= Apartment building function enabled.
DSW4 This enables or disables the pre-blinking function.
Off= Pre-blinking disabled.
On= Pre-blinking enabled.
DSW5 This enables or disables the motor starting function.
Off= Motor starting function disabled
On= Motor starting function enabled
DSW6 This selects the type of intervention of the "FTC" input on opening.
Off= No intervention
On= Temporary stop
DSW7 This selects the type of functioning of the "OPEN" input.
Off= Functioning as "OPEN button"
On= Functioning as "PEDESTRIAN button"
DSW8 It enables the activation of the sensor connected to SENS_H during the opening phase.
Off= Enabled in both opening and closing phases.
On= Enabled only in the closing phase.
"By-pass" dip-switch function
The "By-pass" dip-switches allow to exclude the normally closed inputs which are not in use
DSW1 Input Stop
Off= Enabled input
On= Disabled input.
DSW2 Input FTC
Off= Enabled input
On= Disabled input.
DSW3 Input FCA
Off= Enabled input
On= Disabled input.
DSW4 Input FCC
Off= Enabled input
On= Disabled input.
Trimmer functions
TCA This allows the automatic re-closing time to be adjusted when this is enabled by positioning the
DSW2 Dip-switch on OFF. Adjustment can be from a minimum of 10 to a maximum of 200 seconds.
The minimum time is obtained by rotating the trimmer completely anticlockwise.
TL This allows the working time of the automation to be adjusted. If the limit switches fail, the soft-ware
protection will intervene after this time has elapsed. (Add about 4 sec. to the actual stroke time of
the automation). Adjustment can be from a minimum of 10 to a maximum of 200 seconds.
The minimum time is obtained by rotating the trimmer completely anticlockwise.
7