Publicidad
English
1.
How to access programming
"The Programming operations can only be performed if the
!
function USER PROGRAMMING is activated”.
To access programming, keep the PROG (35) key pressed down
until an audio signal is issued from the machine and the following
message is displayed:
user dose setup
press a key
2.
User dose
user dose setup
press a key
2.1
User dose - programming the cappuccino distribution keys
PROGRAMMING THE CAPPUCCINO DISTRIBUTIN KEYS
(36, 37, 38 and 39 of the group on the right as seen by the
operator)
N.B.: Valid only if the CAPPUCCINO function is activated.
When one of the cappuccino distribution keys is pressed (shown
by the flashing led), the following message will be displayed:
coffee dose
To perform the coffee dose programming, follow the procedure
herebelow:
1) Fill the filter carrier (49) with the correct dose of ground coffee)
and insert into the group ensuring it is correctly locked in place (do
not use previously used coffee grounds).
2) Place the cup by the filter carrier spout (49).
3) Keep the distributor key pressed, as evidenced by the flashing led
(the coffee dose counter starts from zero and increases in value).
4) When the quantity of the coffee in the cup has reached the
desired level, release the key (the counter will indicate the number of
pulses that correspond to the set dose).
It is possible to vary the set dose via the “+” (72) and “-” (73) keys
(the value of the coffee dose can also be increased or decreased).
N.B.: If the coffee dose is set to “000”, the key may only be used for
milk distribution.
When the
(71) key is pressed, the following message is
4 4 4
displayed
milk
To memorize the programming of the milk dose, follow the proce-
dure herebelow:
key 03
4
100
key 03
4
10.0
During the programming phase, the audio signal will be repeated
every 10 seconds.
To return to the programming phase, keep the PROG (35) key pressed
down until the following message is displayed:
boiler pressure
1,00 bar
When one of the dose distribution keys are pressed (cappuccino,
coffee, milk or hot water), its value can be programmed.
1) Place the cup (containing a previously programmed dose of coffee)
by the cappuccino maker (29).
2) Keep the distributor key pressed, as evidenced by the flashing
led (the coffee dose counter starts from zero and increases in
value).
3) When the quantity of milk in the cup has reached the desired level,
release the key (the counter will indicate the rime that correspond to
the set dose).
It is possible to vary the set dose via the “+” (72) and “-” (73) keys
(the time value of the milk dose can also be increased or
decreased).
N.B.: If the coffee dose is set to “00.0”, the key may only be used
for coffee distribution.
When the
(71) key is pressed, the following message is
4 4 4
displayed
milk start
The “start milk” time can be increased or decreased using the “+”
(72) and “-” (73) keys.
When the “00” value is set, first milk and then coffee will be distributed
into the cup.
When the “01” value is set, the distribution of milk and coffee will be
simultaneous.
When any of the other values (max. 60) are set, the coffee will be
distributed first, and after a set period of time the milk will be distributed.
N.B.: When high values are set (above the coffee distribution times),
the milk distribution will start upon completion of the coffee distribution.
How to perform other operations
The programming of another key is made by pressing one of the
other distribution keys.
When the
(71) is pressed, the message “user dose” (Paragraph
4 4 4
2) will be displayed.
When the PROG (35) key is pressed, the message “clock
program” is displayed (See Paragraph 3).
English
key 03
4
10
Publicidad
