TEUFELBERGER pulleySAVER Manual Del Usuario página 11

Beware that lateral movements by the climber may cause
the anchor device to migrate across the structure to a
location where it is no longer suitable for use as a fall pro-
tection anchor. It is the user's responsibility to monitor the
anchor device.
The climbing rope should always be put through the thim-
ble which takes over the function of the retrieval snap.
The angles indicated on the label is observed!
Ad 2. Choked
This configuration can be adopted when the desired anchor
location is on a relatively featureless tree stem. In order to
choke the tree effectually the Prusik loop must be passed
through the soft eye. Note that lateral movement may incre-
ase or decrease the choking action. It is the responsibility
of the user to locate the anchor device appropriately in
relation to the anticipated site of work.
Ad 3. Double strand – Wrapped
This configuration again allows the establishment of an
anchor on a relatively featureless stem. The pulleySAVER
must be wrapped tightly around the tree trunk to give suf-
ficient grab. The pulley is passed through the soft eye. The
Prusik loop does not pass through the soft eye. The bite of
the Prusik loop allows some freedom of movement for the
pulley.
fig. 6
MODES OF USE
fig. 4
fig. 5
fig.7
11