Mopar 82211665AD Instrucciones De Montaje página 3

CAUTION: To avoid damage to any of the parts, do not
install the hood scoop bezels with power tools,
4. Using a Phillips screwdriver, install the hood scoop
bezel (3) to the hood scoop (1). Insert the screws
(2) provided in the kit through the hood scoop bezel
(3) and into the hood scoop (1). Tighten the screws
(2) until tight. Repeat steps for opposite side of hood
scoop (1).
5. Wet the gasket installation area on the hood with a
50/50 mixture of isopropyl alcohol and water. This will
prevent the gasket (1) from immediately sticking to the
hood and allows you to easily adjust the gasket (1) into
position. The mixture will not interfere with the adhe­
sion after it has evaporated.
CAUTION: Take caution not to tear or rip any part of
the gasket.
6. Carefully remove the tan adhesive backing from the
gasket (1).
7. Install the gasket (2) to the hood scoop channel. The
rear portion of the gasket (2) must be lined up with the
edge of scoop channel. Have an assistant hold the
gasket in place while the other person aligns and pro­
motes the adhesion of the gasket (2).
CAUTION: Take caution not to tear or rip any part of
the gasket.
8. Once aligned, press down firmly on the gasket (2) for
30 seconds to allow for proper adhesion.Let the 50/50
mixture of isopropyl alcohol and water dry com­
pletely before proceeding with the hood scoop in­
stallation portion.
Jan 21, 2011
www.mopar.com
3
K6869570 Rev 2