Tabla de contenido
Publicidad
COMMON ERRORS / ERRORES COMUNES / ERREURS COMMUNES / GLI ERRORI PIU COMUNI
ERROR
POSSIBLE CAUSES
CODE
E1
Defection on speed sensor.
E2
Overload or over voltage protected.
E3
Over current protected
E4
Defection on motor
E5
PCB Driver overload
Defection on the cables between computer and
E6
controller
E7
Safety key off
E0P
Error on controller proofreading with motor.
PROBLEM
1.Not plugged in.
2.Safety key not attached correctly.
Treadmill will not
3.Treadmill circuit breaker tripped.
start
4.On/Off switch not turned on.
5.Auto shut down timed out.
1.Walking belt too loose.
Treadmill belt
slipping
2.Deck needs lubrication.
1.Loose hardware.
2.Motor straining.
Treadmill noisy
3.Clicking sound-roller knocking.
1.Too much hand movement.
2.Palms too wet.
Inaccurate pulse
rate
3.Gripping handgrips too tight.
4.Wearing rings.
/ HÄUFIGE FEHLER / VEELVOORKOMENDE FOUTEN / ERROS COMUNS
POSSIBLE CAUSES
CORRECTION
Check whether the speed sensor is installed well, whether the
sensor is broken, and whether the distance between sensor and
roller is in 3-5MM.
Switch off the power and switch on the power again.
Switch off the power and switch on the power again.
1.Check cable connection between motor and controller.
2.Check whether the motor is broken.
Replace this PCB, or check the cause of overload.
Check whether the upright cables are well-connected;
Attached the safety key correctly.
Contact your dealers to solve the problem
CORRECTION
1.Tighten into suitable outlet.
2.Insert safety pull pin.
3.Reset circuit breaker.
4.Turn on On/Off switch.
5.Unplug and re-plug electrical cord.
1.Tighten walking belt.
2.Lubrication belt and deck.
1.Tighten visible screws, nuts and bolts.
2.Check the belt tension-3 finger test.
3.Adjust rear rollers-check the tension.
1.Stand on the side rails to obtain accurate pulse reading.
2.Dry palms.
3.Grip using moderate pressure.
4.Remove all rings.
FYTTER |WWW.FYTTER.COM
PAG- 54
Publicidad
Tabla de contenido
