Furniture Door Dimensions; Connecting The Appliance; Electrical Connection - Gaggenau RB 280 Serie Instrucciones De Uso

Furniture door dimensions

Key
A Furniture door protrusion
B Lower edge of furniture door
The specified furniture door dimensions apply for a
door gap of 5 / '' (4 mm).
32

Connecting the appliance

After installing the appliance, wait at least 8 hours
until starting up the appliance. During transportation
the oil in the compressor may have flowed into the
refrigeration system.
Before switching on the appliance for the first time,
clean the interior of the appliance (see chapter
Cleaning the appliance).

Electrical connection

9
WARNING:
Risk of electric shock!
Connect the appliance to a grounded, 3-phase outlet
only. Never remove the ground phase. Do not use any
adapters.Do not use any extension leads.
9
WARNING:
Risk of electric shock!
Incorrect connection of the appliance may result in
death, fire or electric shock. Improper connection of
the protective conductor may result in electric shock.
If you are in doubt as to whether the appliance has
been properly grounded, have it tested by a qualified
electrician or Customer Service technician.
9
WARNING:
Risk of electric shock!
If the length of the power cord is inadequate, never
use multiple outlets or extension leads. Instead,
please contact Customer Service for alternatives.
This appliance must be connected to a permanently
installed outlet.
The outlet must be near the appliance and also freely
accessible following installation of the appliance.
The appliance complies with protection class I.
Connect it to a correctly installed outlet. Correct
means: with a protective conductor, 110 V – 120 V/
60 Hz alternating current. The outlet must be
protected by a 10 A – 16 A fuse.
The appliance comes with a UL registered 3-wire
power cord. The appliance requires a 3-pole outlet.
Please observe the following table with regard to this:
Appliance
Fridge-freezer
Check on the rating plate whether the indicated
voltage and current type match the values of your
power supply. The position of the rating plate can be
found in the chapter entitled Customer Service.
9
WARNING:
Never connect the appliance to electronic energy
saver plugs.
Our appliances can be used with mains and sine-
controlled inverters. Mains-controlled inverters are
used for photovoltaic systems which are connected
directly to the national grid. Sine-controlled inverters
must be used for isolated applications (e.g. on ships
or in mountain lodges) which are not connected
directly to the national grid.
Maximum simultaneous
load
6 A
7