Mopar 82212439 Instrucciones De Montaje página 3

3
14. Install the edge biter clip (2) to the rear notch of the driver side vertical intake manifold fin.
15. Continue routing the engine block heater cord (1) outboard of the passenger side vertical intake manifold fin.
16. Install the edge biter clip (2) to the forward notch of the passenger side vertical intake manifold fin.
17. Install the retainer clip to the hole on the passenger side of the front end module.
18. Secure the engine block heater cord (1) to the injector
to engine controller wiring harness with tie straps (2).
Sep 14, 2010 K6861087 REV 1