Electrical Connection; Technical Data - SCHOLTES LVL 12-67 Manual De Instrucciones

Connecting the water outlet hose
Connect the outlet hose (without bending it) to a
drain duct with a minimum diameter of 4 cm.
Alternatively, rest it over a sink or tub; the free
end of the hose should not remain immersed in
water.
A
should be between 40 and 100 cm above the
ground ( see figure ).
 We advise against the use of hose extensions.

Electrical connection

Before inserting the plug into the electrical socket,
make sure that:
• the socket is earthed and complies with current
regulations;
• the socket can withstand the maximum load of
the appliance, which is indicated on the data
plate located on the inside of the door ( see
Description of the appliance );
• the power supply voltage falls within the values
indicated on the data plate on the inside of the
door;
• the socket is compatible with the plug of the
appliance. If this is not the case, ask an
authorised technician to replace the plug ( see
Assistance ); do not use extension cables or
multiple sockets.
 Once the appliance has been installed, the
power supply cable and the electrical socket
should be easily accessible.
 The cable should not be bent or compressed.
 The cable should be checked regularly and
replaced by authorised technicians only ( see
Assistance ).
 The Company shall not be held responsible for
any incidents that occur if these regulations are
not observed.
The special plastic
elbow* makes it easier
to find the best layout:
fix the elbow to the wall
securely in order to
prevent the outlet hose
from moving and spilling
the dirty water.
The part of the hose
marked with the letter A
Advice regarding the first wash cycle
After the appliance has been installed,
immediately before running the first wash cycle,
completely fill the salt dispenser with water and
add approximately 2 kg of salt ( see Rinse aid and
refined salt ). The water may overflow: this is
normal and is not a cause for concern. It is also
normal if the LOW SALT* indicator light continues
to flash for a few washes after the salt has been
loaded, or if the text NO SALT appears on the
display for a few washes.
Anti-condensation strip*
After installing the dishwasher, open the door and
stick the adhesive transparent strip under the
wooden shelf in order to protect it from any
condensation that may form.

Technical data

width 59.5 cm
Dimensions
height 82 cm
depth 57 cm
Capacity
12 standard place-settings
Water supply 30 Kpa ÷ 1Mpa (0.3 ÷ 10 bar)
pressure
4.3 psi – 145 psi
Power supply
See appliance data plate
voltage
Total absorbed
See appliance data plate
power
Fuse
See appliance data plate
This dishwasher conforms to
the following European
Community Directives:
-73/23/EEC dated 19/02/73
(Low Voltage) and subsequent
modifications
-89/336/EEC dated 03/05/89
(Electromagnetic Compatibility)
and subsequent modifications
-97/17/EC (Labelling)
-2002/96/ CE (
Electrical and Electronic
Equipment WEEE)
* Only available in selected models.
EN
Waste
15