Assembly Concrete Wheel Base - Extremis INUMBRA Manual De Instrucciones

6. Use the handle provided for opening and closing the
parasol to tighten the lower adjusting screw so that the
parasol is firmly fixed. Rotate the handle clockwise to
tighten.
To remove the parasol afterwards, completely loosen
the lower adjusting screw. Only then will you be able
to remove the parasol.

ASSEMBLY CONCRETE WHEEL BASE

1. Put the four concrete tiles on top of the frame with
wheels. Align the holes in the concrete tiles with the
holes in the metal plate of the cross-shaped base. The
side with the bevelled corners should be facing
downwards.
7. Put rubber cap in the lower hole after installation.
Open and close Inumbra using upper hole only!
ATTENTION
: there is a 5mm gap between the parasol
tube and the tube installed on the concrete base in
order to ensure a proper fixation. As a result, the
parasol will not be able to loosen by movement.
2. Position the stainless steel tube on top of the concrete
tiles. Make sure that the holes in the stainless steel
disk are perfectly aligned with the holes in the
concrete tiles. Position the flat section of the conical
part of the stainless steel tube where you wish your
handle to be. You can now attach the stainless steel
tube to the concrete tiles using the four supplied bolts.
Tighten them with a 17 mm openend wrench.
english 7