Publicidad
Idiomas disponibles
Idiomas disponibles
2.2.Cooling description
This digital amplifier series is designed according to international 1 U size standards. The cooling
method is: pumping the outside air into inside the unit through the vents of the front panel, and
then bring out the heat through the aluminum radiator in the unit and then out from the rear
panel vents. The "smart" variable speed DC fan is equipped in the unit, and then it can adjust
the wind speed through the temperature detection and circuit detection for the heat sink mo-
dule. When the unit inside overheats, it will adjust the fan speed to increase cooling efficiency
immediately.
If any heat-sink overheats, the detection circuit will reduce output power. If the amplifier over-
heats, the temperature protection detection circuit and its circuit will shut down and power off
until it cools to a safe temperature.
After using this unit for a period of time (not referring to the turn- on time), if it can not meet the
cooling effect after the fan running with high speed for a long time, please turn off the machi-
ne and remove the mesh enclosure to clean up the dust (only for the unit with the mesh enclo-
sure design).
The air flow diagram of the unit cooling is shown as below, please ensure that there is enough
space for the fixed installation of the unit.
(The renderings are only for reference, and the actual item is the standard.)
2.3.Connection mode illustration
2.3.1.Stereo mode connection illustration
2.3.2.Mono mode connection illustration
29
Publicidad
