MBM SAE561M Manual Del Usuario página 13

INSTALLATION AND CONNECTION TO THE POWER SUPPLY
The manufacturer declines any liability for
damage caused by improper or incorrect
installation or maintenance of the appliance, or
failure to observe safety regulations.
Remove the appliance packaging as well as the
protective plastic sheet. If necessary, remove
any glue with a suitable solvent. Dispose of the
packaging according to local regulations (for
more details refer to the chapter "ECOLOGY
AND THE ENVIRONMENT").
When installing the appliance, all the
regulations in force must be observed, such as:
 Applicable national laws in force;
 Regional and/or local regulations, such as
building regulations;
 Directives and regulations stipulated by the
local electricity supplier;
 Accident prevention regulations in force;
 Fire prevention regulations;
The appliance should be installed under an
extractor hood so that cooking fumes can be
removed. The equipment can be placed on a
work surface or installed on a wall. The distance
from adjacent equipment or from flammable
surfaces must be at least 300 mm from the sides
and 100 mm from the rear wall. The appliance,
and more specifically, the power cord, must not
be positioned near
temperature in the area surrounding the
appliance must not exceed 50°C.
Before proceeding with the connection,
compare the appliance data (the technical data
can be found on the ratings plate on the rear
panel of the appliance) with power delivery on
site.
heat sources; the
The appliance is supplied with a power cord;
the installer must connect it after interposing
the main power supply cut-off switch. The
opening contacts must be minimum 3 mm
apart per pole. The cut-off device must be easily
accessible.
If the power cord must be
replaced,
instructions in the wiring diagram
attached to this manual.
The power cord must not have characteristics
lower than H07 RN-F and must have a
minimum cross-section as indicated on the
cover. The appliance must be connected to an
effective earth socket. There is a connection on
the terminal board for this purpose that is
identified by the symbol
conductor is to be connected. Furthermore, the
appliance must be included in an equipotential
system. The connection is made to a specific
terminal, marked with the symbol
back panel of the appliance.
To access the terminal board "M" remove the
panel "P" on the back (_SE_40, _SE_60 and
SE_80) or side (SEL_); disconnect the wires from
the terminal board, loosen the cable gland "AL"
and replace the cable in reverse order.
EN - 3
following
to which the earth
, on the
the