DeWalt DW650 Traducido De Las Instrucciones Originales página 25

d) Remove any adjusting key or wrench
before turning the power tool on. A
wrench or a key left attached to a rotating
part of the power tool may result in personal
injury.
e) Do not overreach. Keep proper
footing and balance at all times. This
enables better control of the power tool in
unexpected situations.
f) Dress properly. Do not wear loose
clothing or jewellery. Keep your hair,
clothing and gloves away from moving
parts. Loose clothes, jewellery or long hair
can be caught in moving parts.
g) If devices are provided for the connection
of dust extraction and collection facilities,
ensure these are connected and properly
used. Use of dust collection can reduce
dust-related hazards.
4) POWER TOOL USE AND CARE
a) Do not force the power tool. Use the
correct power tool for your application.
The correct power tool will do the job
better and safer at the rate for which it
was designed.
b) Do not use the power tool if the switch
does not turn it on and off. Any power
tool that cannot be controlled with the switch
is dangerous and must be repaired.
c) Disconnect the plug from the power
source and/or the battery pack from
the power tool before making any
adjustments, changing accessories, or
storing power tools. Such preventive safety
measures reduce the risk of starting the
power tool accidentally.
d) Store idle power tools out of the reach
of children and do not allow persons
unfamiliar with the power tool or these
instructions to operate the power tool.
Power tools are dangerous in the hands of
untrained users.
e) Maintain power tools. Check for
misalignment or binding of moving parts,
breakage of parts and any other condition
that may affect the power tool's operation.
If damaged, have the power tool repaired
before use. Many accidents are caused by
poorly maintained power tools.
f) Keep cutting tools sharp and clean.
Properly maintained cutting tools with sharp
cutting edges are less likely to bind and are
easier to control.
g) Use the power tool, accessories and
tool bits etc., in accordance with these
instructions taking into account the
working conditions and the work to
be performed. Use of the power tool for
operations different from those intended
could result in a hazardous situation.
5) SERVICE
a) Have your power tool serviced by a
qualified repair person using only identical
replacement parts. This will ensure that the
safety of the power tool is maintained.
Additional Specifi c Safety Rules
for Sanders
• Hold power tools by insulated gripping
surfaces when performing an operation
where the cutting tool may contact hidden
wiring or its own cord. Cutting accessory
contacting a "live" wire may make exposed
metal parts of the tool "live" and shock
the operator.
• Take special care when sanding some woods
(e.g. beech, oak) and metal which may produce
toxic dust. Wear a dust mask specifically
designed for protection against toxic dust
and fumes and ensure that persons within or
entering the work area are also protected.
• Use this tool in a well-ventilated area when
sanding ferrous metals. Do not operate the tool
near flammable liquids, gases or dust. Sparks
or hot particles from sanding or arcing motor
brushes may ignite combustible materials.
• Hold power tool by gripping surfaces,
because the belt may contact its own cord.
Cutting a "live" wire may make exposed metal
parts of the power tool "live" and shock the
operator.
Sanding Paint
WARNING: Observe the applicable
regulations for sanding paint. Pay
special attention to the following:
1. Whenever possible, use a vacuum
extractor for dust collection.
2. Take special care when sanding paint
which is possibly lead based:
– Do not let children or pregnant
women enter the work area.
– All persons entering the work area
should wear a mask specially
designed for protection against
lead paint dust and fumes.
– Do not eat, drink or smoke in the
work area.
EN GL IS H
23