Front View - SCOPREGA GE 21-1 Manual De Instrucciones

3. DO NOT immerse charger in water or any other liquid.
WARNING: DO NOT ALLOW ANY LIQUID TO GET INSIDE THE CHARGER.
ELECTRIC SHOCK MAY RESULT
4. DO NOT attempt to charge the battery with any chargers other than the ones in this manual. The
charger and battery are specifically designed to work together.
5. The charger is not intended for any use other than charging the battery in the Inflator. Any other
uses may result in risk of fire, electric shock or electrocution.
6. Make sure cord is located so that it will not be stepped on, tripped over, or otherwise subjected
to damage or stress.
7. Do not operate charger with a damaged cord or plug.
8. Do not operate the charger if it has received a sharp blow, been dropped, or otherwise damaged
in any way.
9. Do not disassemble charger. Incorrect reassembly may result in a risk of electric shock,
electrocution or fire.
10. Never use another products charger to charge this product.
Always use only original spare partes.
11. TO OPERATE THE INFLATOR INSERT THE FUSE, LOCATED INSIDE THE CARRY BAG, FIRST.
12. CHARGING TIME MAY TAKE UP TO 8 HOURS.
13. FULLY CHARGE THE BATTERY AND DISCONNECT THE FUSE IF YOU DO NOT ACTIVATE THE
INFLATOR FOR MORE THAN 30 DAYS.
INTRODUCTION
The GE 21 is a single cylinder pump able to inflate at any pressure between 10 and 1500 mbar.
The pump starts when the ON push botton is pressed and automatically switches off when the set
pressure is reached. The OFF button stops the unit when pressed by operator. GE 21 is fully portable
since a battery is included in the unit. In case of battery LOW it is possible to connect the Unit to a
Cigarette Plug. The Unit can be recharged by a 110 - 240 Vac Adaptor or by a 12Vdc Cigarette Plug.
Suggested Uses:
• Large Rigid inflatable like SUPs / Inflatable Boats, Kayak, Kites etc.,
• Lazarettes for Super Yachts
• Rafts, air mattresses, swimming pool floats, etc.
Characteristics:
• Capacity
• Max Pressure
• Pressure setting
• Modes
• Safety Fuse
• External Battery Port
• Inflation fittings
• Carry bag dimensions
125 L/min
1500 mbar (22 psi)
Gauge with auto shut off
INFLATE
30 Amps
Cable with cigarette plug
available for most common valves
220x320x220 mm
Raccordi di gonfiaggio
•
Dimensioni borsetta a tracolla
•
FEATURES
DESCRIZIO N E F UN Z IO N A LE
1. Pressure knob
1. Pressostato
2. Manometro
2. Gauge
3. Tasti On - Off
3. ON-OFF switches
4. Presa per ricarica
4. Port for recharge
5. Bocca d'ingresso (sgonfiare)
6. Bocca d'uscita (gonfiare)
5. Inlet port
7. Cavo con presa accendisigari 12V
6. Outlet (inflate) port
8. Tubo aria con adattatori
7. 12 Vdc Vehicle Cable Plug
9. Trasformatore 110-240 V
8. Air hose with adaptors
9. 110-240 V charger
Plug for Sefety Fuse 30A
HOSE AND CORD STORAGE
• The 12 Vdc cords and the air hose are located in the carry bag
• The accessories like 110 – 240 Vac Battery Charger and cigarette Plug are stored on the lower
compartment of the carry bag.
FITTING THE ACCESSORIES
• Your inflator is supplied with the standard tapered nozzles that are located inside the lower
compartment of the carry bag.
• Make sure that the Unit is OFF
• Remove the hose from the storage location
• Press the air hose clips to the port to inflate (OUT)
• Fit the air hose adaptor to the inflatable
disponibili per tutte le più comuni valvole
220x320x220 mm
6 1 5
3
9
4

FRONT VIEW

Plug for Recharge adaptor
USE of GE 21
2
7
8