Install Additional Modules; Preparation For Use - Hach 5500sc SiO2 Manual De Instalación

Connect to the digital inputs
The analyzer can receive a digital signal or contact closure from an external device that causes the
analyzer to skip a sample channel. For example, a flow meter can send a digital signal when the
sample flow is low and the analyzer skips the applicable sample channel. The analyzer continues to
skip the applicable sample channel until the digital signal stops. All sample channels cannot be
skipped. A minimum of one sample channel must be in use.
Note: If all of the sample channels have no sample, the user cannot put the analyzer in shutdown mode with the
digital inputs. To put the instrument into shutdown mode or back into operation remotely, use the optional Modbus
module and write to Modbus register 49937. Write 40007 (decimal) to put the analyzer in shutdown mode. Write
40008 (decimal) to put the analyzer back into operation.
Each digital input can be configured as an isolated TTL type digital input or as a relay/open-collector
type input. Refer to Figure
low = 0 to 0.8 VDC and logic high = 2 to 5 VDC; maximum voltage 30 VDC). Refer to
connections overview
Figure 15 Isolated TTL type digital input
1 Jumper (12x)
2 Digital input connectors

Install additional modules

Modules can be added for additional output, relay or communications options. Refer to the
documentation that is supplied with the module.

Preparation for use

Install the analyzer bottles and stir bar. Refer to the operations manual for the startup procedure.
15. By default, the jumpers are set for isolated TTL type digital input (logic
on page 13 to connect the device.
3 Isolated TTL type digital input
4 Relay/Open-collector type input
Wiring
English 17