Operation - Hoefer UVC5000 Manual Del Usuario

Note: For 230V models, or
those requiring special power
cord connectors, ensure that
the correct type of male
connector or plug has been
properly attached to the
power cord.
Note: When turned on the
crosslinker defaults to the last
used UV exposure setting.
•
p4

Operation

1
Place the Crosslinker on a level work surface. Be sure
there is enough room in front to open the door.
2
Plug the female end of the power cord into the rear
of the Crosslinker.
3
Plug the male end of the power cord into a properly
grounded electrical outlet. The proper operating
voltage of the Crosslinker is found on the product
information label.
4
Turn the On/Off switch to the ON position.
The last UV exposure setting will now be displayed
on the LED. The last function setting will be noted by
glowing red spot(s) on the display panel. Place your
sample into the chamber.