KTM 76008965044 Guia De Inicio Rapido página 4

3
5
4
3
1
2
4
6
A
7
2
4
Scope of supply:
1x wind shield (1)
2x screws M5x17 (2)
2x well nuts (3)
2x dummy plugs (4)
Preassembly
- Remove screws (5) and (6) on both sides.
- Detach the plug-in connections and remove the headlight mask (Figure A).
Assembly
- Cut out the drilling template (7) (see appendix), place on the back of the
headlight mask and mark the drill holes (B).
Remeasure the dimension on the template (distance equals 10 cm) as copy-
ing or incorrect scaling of the printer may result in deviations.
If the template does not have the necessary dimension:
Contact the dealer -> download the PDF and print out again.
Print settings:
Page scaling: NONE and
Choose paper source by PDF page size.
- Drill 10 mm holes at the marks.
- Insert the screw M5x17 (2) (included) at front and the well nut (3)
(included) and dummy plug (4) (included) at the rear on the wind shield
(1) (included).
- Insert the well nuts of the wind shield through the previously drilled holes
and tighten using the screw M5x15 (2).
NOTE:
The well nut tightens and secures the wind shield on the headlight mask.
Final steps
- Connect the plug-in connections of the headlight mask and mount the head-
lights.
Screw (5) 5 Nm
Screw (6) 2 Nm
Check that the headlight and turn signals are functioning properly.
69008021060
60008008050
55003135000