English - geberit AQUACLEAN SELA Instrucciones De Montaje

Adjusting basic settings
to customer's wishes
Adjusting basic settings
The basic settings of the device are set
from the rear of the remote control.
The following steps are shown in shortened
form. See user manual for an overview of
the complete menu.
Prerequisite
– The function test of the device was performed
successfully.
– The function test of the remote control was
performed successfully.
1
Launch [Basic settings] main menu via the
<left>/<right> arrow key. Confirm via the
<down> arrow key
Basic settings
Select submenus with the <up> and <down>
arrow keys. Configure settings with the
<left> and <right> arrow keys.
2
Launch the [Select language] menu. Set the
menu language.
Select language

English

3
Launch the [Spray intensity] menu. Set the
spray intensity.
Spray intensity
4
Launch the [Spray arm position] menu. Set
the spray arm position.
Spray arm position
45035999965553803-1 © 02-2019
968.336.00.0 (02)
5
Launch the [Spray intensity Lady] menu. Set
the spray intensity of the Lady shower.
Spray intensity Lady
6
Launch the [Spray arm pos. Lady] menu.
Set the spray arm position of the Lady
shower.
Spray arm pos. Lady
7
Launch the [Shower water heating] menu.
Set the shower water heating.
Shower water heating
off
8
Launch the [Oscillating spray] menu. Switch
the oscillating spray off/on.
Oscillating spray
off on
✓ [on] = The oscillating function of the anal
shower is activated.
✓ [off] = The oscillating function of the anal
shower is deactivated.
9
Launch the [Orientation light] menu.
Configure switch-on behaviour.
Orientation light
Automatic
10
Launch the [Orient. light colour] menu. Set
colour.
Orient. light colour
blue
If Geberit Monolith Plus is installed, select
the same colour.
11
Launch the [Orient. light bright.] menu. Set
brightness.
Orient. light bright.
EN
41