9
Press (ENTER).
Depending on the aspect ratio of the selected
image, the display type will be set
automatically.
1:1 to 1:4 – tile
more than 1:4 – scroll horizontally
below 1:1 – scroll vertically
10
Press (ENTER) again.
11
Press (GRAPHIC).
The display returns to the normal display.
Press (SCREEN) to turn to the Panorama/
Wall paper mode. Then the adjusted
panorama image is displayed.
Notes
• You can set the image format as follows:
JPEG: 1,600 × 1,200 dots or less
• You can set the display while the unit must be kept
on.
• You can preview up to 100 images from a folder
within a "Memory Stick" at one time.
• The following folders in a "Memory Stick" cannot be
displayed.
– CONTROL
– DCIM
– MSSONY
– VOICE
– HIFI
• In step 5 or 7, if there is no image data, "No Picture"
is shown in the display.
• Depending on the volume of stored data, the storing
time differs. Do not turn off the unit while the
message in step 10 is displayed. If you turn off the
power, the data will not be stored.
• If the capacity of the unit is not enough, "MEM FULL
– delete data" is displayed and you cannot store the
data. After deleting the data (page 37), perform the
settings again.
Tips
• You can store a maximum of 100 panorama images
in the unit.
• If "Cyber-shot" is selected in step 6, the folder is
selected automatically.
About the pre/user strage area capacity
The image is stored in the "Panorama" user area.
A
B
C
A Pre-stored panorama images
B User area of "Panorama"
C Pre-stored wall papers
D
D User area of "Wall Paper"
Tip
Stored images may not display in order of they were
stored.
33