Installing Software - Lancom Systems 8011 VPN Guía De Instalación Rápida

LANCOM Routers, WLAN Routers, Access Points and WLAN Controllers

Installing software

If you use a Windows PC for configuration, you should
(LANconfig and LANmonitor of the included CD).
Alternatively, or in case of other operating systems, it is possible to
web browser for configuration.
Setting up and connecting the device
Put up LANCOM/mount. While doing so, please
advices regarding the ambient conditions, stackability etc. of the technical
data in the User's
Some devices (e.g. with integrated ADSL modem) may become quite

warm in operation. For these models, ensure an ambient air tempera-
ture of 35°C at maximum. Take care of sufficient ventilation. Do not
stack devices and do not expose them to direct insolation!
Install/connect
necessary.
Antennas are only to be attached or changed when the device is

switched off. Mounting or demounting antennas while the device is
switched on may cause the destruction of the WLAN module! When
installing outdoor antennas, the instructions on installation and
grounding in the LANCOM Antenna Installation Guide must be
observed.
Connect LAN and WAN ports
Supply power
necessary, switch on the power switch.
Some devices support power supply via the LAN cable (Power-over-

Ethernet – PoE). Please notice the corresponding advice at the rear of
your device.
Manual.
additional antennas
to the corresponding remote stations.
via the provided power supply unit resp. power cable. If
Install LANtools
follow the installation
for LANCOM Wireless devices, if
First steps
use a
2