Lancom Systems 8011 VPN Guía De Instalación Rápida página 23

LANCOM Routers, WLAN Routers, Access Points and WLAN Controllers
Boot only: A press of the button prompts a restart, regardless of how
long the it is held down.
Reset-or-boot (standard setting): Press the button briefly to restart
the device. Pressing the button for 5 seconds or longer restarts the
device and resets the configuration to its factory settings. All LEDs on
the device light up continuously. Once the switch is released the
device will restart with the restored factory settings.
After applying the reset, the device will start fresh with factory

defaults. All settings will be lost. Therefore, you should save the cur-
rent configuration if possible before the reset!
Please notice that also the WLAN encryption settings of the device will

get lost in case of a reset and the standard WEP key comes into effect
again. The wireless configuration of a device with WLAN interface will
only succeed after a reset, if the standard WEP key is programmed into
the WLAN adapter! After a reset, the LANCOM access point returns to
managed mode, in which case the configuration cannot be directly
accessed via the WLAN interface!
Further information and support
Should you have any queries, or should you require any further support regar-
ding the topics discussed in this documentation, the following sources of
information are available to you:
In the service- & support section
answers on „Frequently Asked Questions ('FAQs')" can be found, the LAN-
COM knowledge data base („Support KnowledgeBase" with whole text
search), as well as telephone numbers and contact addresses.
In the download section
firmware, tools and documentation are available at any time.
on www.lancom.eu/support
on www.lancom.eu/download
First steps
many
current drivers,
10