Lancom Systems 8011 VPN Guía De Instalación Rápida página 22

LANCOM Routers, WLAN Routers, Access Points and WLAN Controllers

How to reset the device?
If you have to configure the device regardless of possible existing settings, or
if a connection to the device configuration failed, you can put back the device
into the factory default state with a Reset.
ETH4
The reset button offers two basic functions—boot (restart) and reset (to the
factory settings)—which are called by pressing the button for different
lengths of time.
With the suitable setting, the behavior of the reset button can be controlled
accordingly.
Configuration tool
WEBconfig, Telnet

9
It may not be possible to configure all device functions using
WEBconfig's setup wizards. Use, if necessary, LANconfig for a more
comfortable and more extensive configuration.
ETH3 ETH2 ETH1 WAN
Config(COM) Reset Antenna Main
Call
Expert configuration > Setup > Config
Reset button
This option controls the behavior of the reset button when it is pressed:
Ignore: The button is ignored.
Please observe the following notice:
only' makes it impossible to reset the configuration to the factory set-
tings using the reset button.
If the password is lost for a device with this setting, there is no way to
access the configuration! In this case the serial communications inter-
face can be used to upload a new firmware version to the device-this
resets the device to its factory settings, which results in the deletion
of the former configuration. Instructions on firmware uploads via the
serial configuration interface are available in the LCOS reference
manual.
First steps
Reset switch (according to the model type
on the front or rear panel)
LANCOM 8011 VPN
ISDN COM
The settings 'Ignore' or 'Boot