Troubleshooting Guide - BH FITNESS G2343 Manual De Instrucciones

If no signal is received after a further 5
seconds then the screen will revert to
the previously displayed function.
F. ODOMETER.-
This function shows you the total
accumulated distance that you have
travelled throughout the exercises.
To reset the total distance travelled
(ODO), take the battery cover off (A),
Fig.1, and remove one of the batteries
to deactivate the monitor, and then
replace the battery and the cover (A),
Fig.1.
NOTE:
The ODO function will automatically
reset whenever the old batteries are
replaced with new ones.
HAND-GRIP
STRUCTIONS/USE.-
On this model the pulse rate is
measured by placing both hands on the
sensors (R), located on the handlebar,
as shown in Fig.5.
When both hands are placed on the
sensors the heart symbol on the right-
hand side of the screen, marked
PULSE, will begin to flash and after a
few seconds a heart rate reading will
be displayed.
If both hands are not placed correctly
as shown in Fig.5 then the pulse
function will not work.
If a "0" appears on the screen or the
heart symbol does not flash then make
sure that both hands are placed on the
sensors and that the connectors (54)
and (54a) are connected at the back of
the electronic unit.
(PULSE) IN-

TROUBLESHOOTING GUIDE

Problem: The display comes on but
only the Time function works.
Solution:
a.- Make sure that the connection cable
is connected.
Problem: The display does not come
on or the displayed segments are very
weak.
Solution:
a.- Check that the batteries are fitted
correctly.
b.- Check the battery charge.
c.- If they are run down change them
immediately.
Problem: Display segments of a
function read-out are not visible or error
messages for a particular function
appear.
Solution:
a.- Remove the batteries for 15
seconds and then refit them correctly.
b.- Check the battery charge If they are
run down change the batteries.
c.- If the above steps do not help then
replace the electronic monitor.
Avoid leaving the electronic monitor in
direct sunlight as this might damage
the liquid crystal display. Similarly, do
not expose it to water or knocks.
BH RESERVES THE RIGHT TO
MODIFY THE SPECIFICATIONS OF
ITS PRODUCTS WITHOUT PRIOR
NOTICE
Do not hesitate to get touch with us if
you have any queries, by calling:
+44 0844 335 3988
service@bh-uk.co.uk
9