Installing Your Appliance; Choice Of Location; Fitting - Fagor CFI-4GLSTANAT Manual De Instalación Y Utilizacion

1/ INSTALLING YOUR APPLIANCE

Fig. 01

• CHOICE OF LOCATION

Your appliance must be flush fitted into a
support cabinet surface which is at least 3 cm
thick and is manufactured from heat resistant
material or covered in a heat resistant
coating.
A minimum distance of 30 cm either side of
the hob should be free from any obstructions
(cabinet or panel) which could hinder safe
handling of cooking utensils.
If a horizontal divider wall is positioned under
the hob, it must be located between 10 cm and
15 cm from the top of the work surface. In any
event, do not store aerosol cans or
pressurised containers in any compartments
located under the hob (refer to the " Safety
Recommendations " ) chapter.

FITTING

•
In order to guarantee the seal between the
hob and the work top, the supplied seal must
be glued into the insert prior to hob
installation:
Refer to the diagram (Fig. 01) .
— Remove the pan supports, burner covers
and burner heads; noting their positions.
— Turn the hob over and carefully place it on
top of the opening in the cabinet to prevent
APPLIANCE (60 cm model)
Width
Standard 56 cm
cabinet
cut-out
Total 71 cm
dimensions
above
the work
surface
Total 55.4 cm
dimensions
below
the work
surface
APPLIANCE (30 cm model)
Width
Standard 26.5 cm
cabinet
cut-out
Total 29,3 cm
dimensions
above
the work
surface
Total 26,3 cm
dimensions
below
the work
surface
damage to the knobs and spark plugs.
— In order to guarantee the seal between the
housing and the worktop, stick the foam seal
around the edge of the frame (Fig. 02 ).
Housing
Seal
7
EN
Depth Thickness
49 cm depending
on
cabinet
52.2 cm 5 cm
47 cm 5.1 cm
Depth Thickness
49 cm depending
on
cabinet
52,5cm 5,4 cm
47,9 cm 5.1 cm
Fig. 02