Hotpoint Ariston LD 6090 Manual De Instrucciones página 19

1. Turn the water tap on.
2. Press the STANDBY button: the display will light up.
3. Open the door and pour in a suitable amount of
detergent ( see below ).
4. Load the racks ( see Loading the racks ) and shut
the door.
5. Select a wash cycle by pressing the SELECT
WASH CYCLE button repeatedly until the number
corresponding to the desired cycle appears ( see
Table of Wash Cycles ).
6. Select the wash options ( see below ).
7. Start the cycle by pressing the START/RESET
button: the machine will emit a confirmation beep.
The WASH CYCLE PHASE indicator lights display
the status of the cycle:
Pre-wash, Wash, Rinse, or Drying.
8. At the end of the wash cycle, you will hear two
short beeps and the word "END" will appear on the
display.
9. Switch off the appliance by pressing the
STANDBY button, shut off the water tap and unplug
the appliance from the electricity socket.
10. Open the door and wait for a few minutes before
removing the crockery inside, in order to avoid burns.
Unload the racks, beginning with the lower level.
If dON appears on the display, this means that the
appliance is in demonstration mode. To deactivate
it, press the START/RESET and STANDBY buttons
simultaneously: dOF should appear on the display.
If a mistake was made during the wash cycle selection
process it is possible to change the cycle, provided
that it has only just begun: press and hold the START/
RESET button for 4 seconds. After one long beep and
three short beeps, the WASH CYCLE PHASE indicator
light will switch off: Select the new cycle and switch the
machine back on by pressing the START/RESET button.
Press the STANDBY button and open the door,
taking care to avoid the escaping steam, and place
the crockery inside the dishwasher. Press the
STANDBY button again: the cycle starts from the
point at which it was interrupted.
If the door is opened during the wash cycle (the text
DOOR will appear on the display), or if there is a
power cut, the cycle stops. It starts again from the
point at which it was interrupted once the door has
been shut or the electricity supply is restored.
A successful wash also depends on the correct
amount of detergent being used, as recommended
by the manufacturer. Exceeding the recommended
amount does not result in a more effective wash and
pollutes the environment.
: Washing detergent
: Pre-wash detergent
D
A
B
C
requires 1 tablet, place it in compartment A and
close the cover; when it requires 2, place the
second tablet at the bottom of the appliance.
3. Remove detergent residues from the edges of the
compartment and close the cover until it clicks.
* Only available in selected models.
1. Open cover C by
pressing button D.
2. Pour in the detergent
after consulting the Wash
cycle table :
• for powder detergent
use compartments A
and B
• for tablets, use
compartment A and the
bottom of the appliance,
i.e. when the cycle