Publicidad
Idiomas disponibles
Idiomas disponibles
It is possible to delay the start time of the cycle for a
period of time between 1 and 24 hours.
1. Press the MODE button: select the DELAYED
START symbol.
2. Press the SELECT button to select the desired
delay period.
3. Select the wash cycle by pressing the SELECT
WASH CYCLE button.
4. Press the START/RESET button: after the beep
sounds, the timer begins counting down.
5. Once this time has elapsed, the indicator light
switches off and the wash cycle begins.
To modify the delay and select a shorter period of
time, press the MODE and SELECT buttons to repeat
the selection process.
To cancel it, press the SELECT button repeatedly
until OFF appears on the display, the DELAYED
START symbol switches off, the wash cycle begins
and the WASH CYCLE PHASE indicator light
corresponding to the start of the cycle in progress
illuminates.
If there are not many dishes to be washed, a half
load cycle may be used in order to save water,
electricity and detergent. Before selecting the wash
cycle:
1. Press the MODE button until the HALF LOAD
symbol has been selected.
2. Press the SELECT button, select upper half
loading, lower half loading or OFF (no selection).
3. Select the wash cycle by pressing the SELECT
WASH CYCLE button.
4. Press the START/RESET button; a beep will
indicate that the wash cycle has started.
Remember to load the selected rack only, and to
reduce the amount of detergent accordingly.
It is better to use powder detergent in this case.
This is a special cycle that runs a differentiated
wash on the two racks: a delicate wash on the upper
rack and a more vigorous wash on the lower rack
( see Table of Wash Cycles ).
1. Press the MODE button and select the special
DUO WASH cycle.
2. Press the SELECT button (ON means the cycle is
activated, OFF means it is deactivated).
3. Press the START/RESET button; a beep will
indicate that the wash cycle has started.
Before selecting a wash cycle press the MODE
button and select the EXTRA DRYING symbol.
Press the SELECT button; select ON to activate the
option and OFF to deactivate it.
Press START/RESET; a beep will indicate that the
wash cycle has started.
The overall duration of the programme increases by
approximately 10 minutes when this function is
used.
This function is incompatible with the Soak cycle.
* Only available in selected models.
Publicidad
