Alarm Operation - Tokai TCP-120K-N Manual De Instrucciones

EN

3.ALARM OPERATION

1) Under time display situation, press ALARM key, LCD will display Alarm icon, it means that the
Alarm function is ON.
2) Alarm Setting: When the LCD displays the Alarm icon, press ALARM (4) for 2 seconds to enter into
alarm setting. Press HOUR (2) or MINUTE (1) to set hour and minute, then press ALARM key to
finish setting. Or after 10 seconds, it will exit setup automatically
3) Alarm sound choice(see picture of the ALARM SWITCH - 7)
when you put the switch on BUZ. Then the alarm sound as buzzer.
when you put the switch on RADIO, then the alarm sounds as radio. In this case, if you want to turn
off the radio, you can put the switch on OFF. The projection and the LCD display backlight will be on
no matter you choose Radio or Buzzer for alarm sound.
4) Snooze function
If the ALARM SWITCH is on Buzzer, when the alarm rings, the LCD display and projector will light ON
and the alarm symbol will be flashing on the LCD, then press SNOOZE (5) to suspend the alarm. When
the alarm symbol is still flashing, 9 minutes later the alarm will ring again. Press SNOOZE key again,
alarm will be suspended again, another 9 minutes later will ring again, and so on until the next alarm
rings.
If you want to disable the SNOOZE function, short press ALARM key.
During the SNOOZE function, even though the alarm is suspended, the projector and the LCD display
will remain ON.
-10-