Hansgrohe Metropol S 14061 Serie Instrucciones De Montaje página 7

Attention! The fitting must be installed,
flushed and tested after the valid norms.
Assembly
1. Flush through the supply pipes.
2. Place the mixer including the sealing washer
in position on the basin.
3. Slip the slide washer, washer and collar nut
over the hose and threaded base and tighten
the collar nut by hand.
4. Tighten screws.
5. Connect the supply pipes to the isolation
valves;
cold right - hot left.
6. Connect the pull rod to the pop-up waste.
The pressures of the cold and hot water connec-
tions must be balanced.
Operation
The mixer is activated by lifting the lever handle.
Move to the left = hot water,
move to the right = cold water.
Technical Data
This mixer series-produced with water-
dimmer (flow limiter)
®
Rate of flow with waterdimmer:
Rate of flow without waterdimmer: 14 l/min 3 bars
Operating pressure:
Recommended operating pressure: 1 - 5 bars
Test pressure:
Hot water temperature:
Recommended hot water temp.:
English
Hansgrohe single lever mixers can be used
together with hydraulically and thermically con-
trolled continuous flow heaters if the flow pressure
is at least 1.5 bars.
If the continuous water heater causes any prob-
lems or there is not enough flow of water, the
waterdimmer
must be removed.
To adjust the hot water limiter on single lever mix-
ers, please see page 14.
No adjustment is necessary when using a continuous
flow water heater.
Spare parts (see page 4)
1
1.1 screw cover
2
3
4
5
6
7
8
9
10
11
7 l/min 3 bars
12
13
max. 10 bars
Special accessories
16 bars
X
max. 80° C
65° C
XXX = Colors
000 = chrome plated
880 = satin chrome
(6a) located behind the aerator
®
handle
flange
nut
cartridge cpl.
seal
aerator cpl.
fixing set
connection hose
pop up rod
ball joint
aerator cpl.
supply pipe
connection hose
special tool set
(not part of delivery)
14895XXX
96338000
97406XXX
97209000
92730000
95008000
97370XXX
13961000
96321000
96657XXX
97362XXX
97360XXX
96638000
97206000
58085000
7