If you have problems with your system, look
through this chart and see if you can solve
the problem yourself before calling your
dealer or TEAC service center.
General
No power
e Check the connection to the AC power
supply. Check and make sure the AC
source is not a switched outlet and
that, if it is, the switch is turned on.
Make sure there is power to the AC
outlet by plugging another item such as
a lamp or fan into the outlet.
No sound from speakers.
e Select the source by pressing the
TUNER, CD or AUX button.
e Adjust the volume.
e Pull out the headphone's plug from the
PHONES jack.
e If "MUTING" is blinking, press the
MUTING button.
The sound is noisy.
e The unit is too close to a TV or similar
appliances. Install the unit apart from
them, or turn them off.
Remote control doesn't work.
e Press the STANDBY/ON switch to turn
the unit on.
e If the battery is exhausted, replace it
with a new one.
e Use remote control unit within the
range (5 m) and point at the remote
sensor on the front panel.
e Clear obstacles between the remote
control unit and the main unit.
e If a strong light is near the unit, turn it
off.
34
Troubleshooting
CD Player
Will not play.
e Load a disc with the playback side
facing away.
e If the disc is dirty, clean the surface of
the disc.
e A blank disc has been loaded. Load a
prerecorded disc.
e Depending on the disc, etc. it may not
be possible to play back CD-R/RW discs.
Try again with another disc.
e You cannot play back unfinalized CD-
R/RW discs. Finalize such a disc in a CD
recorder and try again.
Sound skips.
e Place the unit on a stable place to avoid
vibration and shock.
e If the disc is dirty, clean the surface of
the disc.
e Don't use scratched, damaged or
warped discs.
Tuner
Cannot listen to any station, or signal is
too weak.
e Tune in the station properly.
e Rotate the FM antenna (or the main
unit) for the best reception position.
If
normal
recovered, unplug the power cord from
the outlet and plug it again.
operation
cannot
be