Publicidad
Idiomas disponibles
Idiomas disponibles
4
12. Review the snap locations (1 & 2) on the mirror as
sembly (3).
13. Begin installation by aligning the snaps on the mirror
cap (1) with the snap locations on the mirror assembly
(2).
14. Verify that all snaps are in the correct position.
15. Apply gentle pressure on the mirror cap (1) until all
snaps are fully seated into the mirror assembly (2).
16. Install the glass case (3) to motor by pushing the glass
case "hooks" into place.
17. Connect the mirror motor glass electrical connector
(2).
CAUTION: Make sure wires are not caught between
the glass case and the motor.
18. If equipped, connect the heater wires (1) by pushing
on the thumb tabs.
19. Push the glass case (3) on until the glass case snaps
are fully seated on motor.
NOTE: An audible snap is normal.
20. Repeat steps for the opposite side.
21. Connect the negative battery cable.
Jun 01, 2010
K6860975
Publicidad
