Change Of Operating Mode; Time And Timer Setting (Clock, Timer On, Timer Off); Time Setting - AZURO BP-85HS-A Manual De Instrucciones

Parameter C
Temperature diff erence
for restart 1 ~ 10°C
(factory setting 2°C)
Parameter F
Evaporator temperature
5.4

CHANGE OF OPERATING MODE

The operating mode of heat pump can be changed only if the equipment is in operation.
Press to switch the equipment on. During operation the display shows the temperature of water at the heat exchanger inlet and indicates the
active operating mode.
Press the key MODE to change the mode (AUTO – HEATING – COOLING). You are able to change the operating mode only if the equipment is in operation.
Press the key◄ or ► to switch the control interface on. Select the parameter for setting the target temperature in question and if you wish to change
its value, press the key SET. Then using the keys ◄ and/or ► , set the new target temperature as required.
The equipment will go off for about three or four minutes and then resume operation in the mode so changed.
5.5
TIME AND TIMER SETTING CLOCK, TIMER ON, TIMER OFF
Note: Both the time and the timer can be set only if the equipment is in standby mode.
Note: If no key is pressed in the course of setting process within the period of approx. 8 s, the screen will change over automatically into its standard display mode.
5.5.1

TIME SETTING

Press the key CLOCK and the time shown on the display will start fl ashing. Press the CLOCK key again and using the arrows◄ and ► set the hour.
Press the CLOCK once more and set the minute in the same way. Finally, confi rm your selection by pressing the CLOCK key.
Parameter d
Incoming water temperature
Parameter E
Coolant temperature
at compressor discharge
Parameter H
Ambient temperature
11