Publicidad
Idiomas disponibles
Idiomas disponibles
2. Slide the stainless steel clips over the bridges and caliper brackets and around the threaded
studs to fasten the cover. Fit should be snug and secure.
3. Install the supplied locknuts onto the threaded studs to bridge. Tighten with 3/8-inch wrench
or socket to 25 inch pounds (about 1/4 turn past finger-tight). Do not over tighten.
4. Use feeler gauge (or business card) to check the clearance between clip and brake rotor. A gap of
at least .013 inch (.32 mm) is recommended (enough to slide a strip of business card paper in and
out without sticking) . Re-install wheel and tighten lugnuts per manufacturer's specification.
6/20/12
K6861536
Publicidad
