Mopar 82213143 Instrucciones De Montaje página 4

4
2. Place the cover over the caliper and position hole in bridge over the threaded stud and onto the
clip (may require some force to pull second hole over stud).
3. Install the supplied locknuts onto the threaded studs to secure bridge to clip. Tighten with 3/8-inch
wrench or socket to 25 inch-pounds (about 1/4 turn past finger-tight). Do not over tighten.
4. Use feeler gauge (or business card) to check the clearance between clip and brake rotor. A gap of
at least .013 inch (.32 mm) is recommended (enough to slide a strip of business card paper in and
out without sticking) . Re-install wheel and tighten lugnuts per manufacturer's specification.
6/20/12 K6861536