Getting Started; Set Up Remote Wind Sensor; Set Up Remote Temperature / Humidity Sensor; Set Up Rain Gauge - Oregon Scientific WMR89 Manual Del Usuario

GETTING STARTED

NOTE Install batteries in the remote sensors before the
base station matching the polarities (+ and -).
NOTE Use alkaline batteries for longer usage and
consumer grade lithium batteries in temperatures below
freezing.

SET UP REMOTE WIND SENSOR

The wind sensor takes wind speed and direction
readings. The sensor is battery operated. It is capable
of transmitting data to the base station wirelessly within
an approximate operating range of 100 meters (328 feet).
To insert batteries:
1
1. Unscrew the anemometer from the wind sensor
carefully.
2. Insert batteries matching the polarities (+ / -) and
replace the anemometer.
SET UP REMOTE TEMPERATURE / HUMIDITY
SENSOR
The remote sensor can collect data from up to 3 channels.
To set up the remote sensor:
1. Slide open the battery door.
2. Slide channel switch to select a channel (1/2/3). Use
a different channel for each sensor.
3. Insert the batteries, matching the polarities (+ / -).
4. Close the battery door.

SET UP RAIN GAUGE

The rain gauge collects rain and takes rainfall readings.
The sensor can remotely transmit data to the base station.
To set up the rain gauge:
1
1. Remove screws and slide the cover off in an upwards
motion.
2. Insert the batteries (2 x UM-3 / AA), matching the polarities
(+ / -).
2
2
4
3
3. Remove the fibre tape.

SET UP BASE STATION

NOTE Install batteries in the remote sensors before the
base station matching the polarities (+ and -).
For continuous use, please install the AC adaptor. The
batteries are for back-up use only.
NOTE Make sure the adaptor is not obstructed and is
easily accessible to the unit.
NOTE The base station and adaptor should not be
exposed to wet conditions. No objects filled with liquid,
such as vases, should be placed on the base station
and adaptor.
To completely disconnect from power, unplug adaptor
from the mains.
To insert batteries:
1. Slide open the battery door.
2. Insert the batteries, matching the polarities (+ / -).
3. Close the battery door.
NOTE Do not use rechargeable batteries. It is recommended
that you use alkaline batteries with this product for longer
performance.
NOTE Batteries should not be exposed to excessive
heat such as sunshine or fire.