Programmed playback
To program an alternative playback order of tracks follow the below steps.
1.
Make sure the unit is not playing a disc.
Press and hold the "PROG" button to activate programming. "00" and "PROG" indicators
2.
will flash on the display.
3.
Select the first track to be programmed using either
Press the "PROG" button again to store and advance to the next programmed track.
4.
The program sequence indication changes to "02" momentarily waiting for your next input.
5.
Repeat the steps above to program more tracks. A maximum of 20 CD tracks can be
programmed.
6.
Press the
7.
You can press the
8.
To erasing a program, during stop mode press
Cassette playback
Adjust the "FUNCTION" selector to "TAPE.OFF"
1.
2.
Press the cassette knob
then close the compartment door.
3.
Press cassette knob
4.
To pause playback, press the cassette knob
button. To resume, press the button again.
5.
To stop the tape, press the cassette knob
Cassette tape Forwarding / Rewinding
1.
Press the cassette knob
desired passage.
2.
Press the cassette knob
Remark:
1. Please note the tape playback direction symbol on cassette door.
2. During fast forwarding/rewinding, the buttons will not be released at
the end of a cassette.
3. To switch off the unit, make sure the cassette buttons are all
released by pressing the cassette knob
Slide the "FUNCTION" switch to the "FM" (mono) or "FM.ST" (Stereo).
1.
2.
Extend the antenna fully and adjust the angle for best reception.
Tune to the required station using the "TUNING" knob.
3.
When the FM – Stereo reception is disturbed slide the switch to FM.
4.
button to begin the programmed playback in the preferred order.
"STOP" button to terminate programmed playback.
CASSETTE PLAYER
button to open the cassette door, insert a cassette tape
button to start playback.
"F.FWD" button /
button to stop fast forwarding/rewinding.
FM RADIO OPERATION
SCD5410 / English Instruction Manual
or
button.
"STOP2 button twice or open the CD door.
button.
"F. REW" buttons until you reach your
button.
4