Specific Operating Instructions
Possible current sources:
-12 Volt
This energizer shall not be
used as an animal trainer
(inside a barn).
3
4
5
Before using the battery for the first time, it should be charged for at least 12 hours using the charger supplied.
During longer breaks in operation (e.g. winter), always recharge the battery! (Trickle charge)
a.) Installation
The device must always be used vertically, see picture above.
b.) Functional description of the unit
Put unit into service WITHOUT fence and earthing. When connecting the 12V accumulator, be sure to observe the
correct polarities (red + and black -). If the fence light (1) flashes green, the unit is ready for use. If in addition the
accumulator light (2) flashes red, check the 12V accumulator for correct voltage. If the fence light (1) does not flash,
check the polarity of the 12V connecting cable on the accumulator or have the unit checked by a technician.
Switch positions:
0 = OFF;
I = reduced current consumption and output power
II = maximum output power and current consumption
c.) Functional description with connected fence system ( fence + earth )
green (1)
light
1
YES
2
YES
3
NO
If neither of the two LEDs is flashing, the battery connection must first be checked for correct polarity and
-
the battery for sufficient voltage. If no error is found, the device should be checked by a specialist.
The green indicator is only used to check the operation, but does not react to faults in the closing system
-
or to a failure of the closing voltage.
If the fence light (1) flashes faster than approx. once per second, the unit must be disconnected at once and checked by
a technician before it can be used again.
Any user of electric fence systems is legally indebted to control the fence-appliance and the fence system regularly, in
accordance with the conditions of use, at least once per day.
visual check of the appliance and the fence system
-
measurement of the minimum voltage of 2500V at each point of the fence
-
This equipment carries a 3-year warranty in accordance with our Warranty Terms & Conditions!
Please see the attached Operating Instructions for safety tips, earthing, commissioning, maintenance of battery
and accumulator, warranty terms and conditions and potential sources of fault!
SERVICE Addresses:
Please contact your specialist dealer
1
2
red (2)
Device function
light
The device operates sufficient charge (> 11.9 V)
NO
YES
The device operates Low load, charge as soon as possible
The device does not
YES
work, no impulse
1 Function light
2
3 2-step switch
4 Battery lid
5 Earth connection
6
6
Battery condition
Protection against deep discharge responded.
Battery is empty, replace or recharge
immediately
3
12V-ACCUMULATOR
indicator light
Fence connection
( = 50%)
( = 100%)
-EN-
Version : 2021.1