Installation; Electrical Installation - Cooke & Lewis CLOV65 Manual De Instalación

Installation

EN

Electrical installation

All installation must be carried out by a competent person or qualified electrician. Before connecting the
mains supply ensure that the mains voltage corresponds to the voltage on the rating plate.
Direct Connection
The appliance must be connected directly to the mains using an omnipolar circuit breaker with a minimum
opening of 3 mm between the contacts.
The installer must ensure that the correct electrical connection has been made and that it complies with
the wiring diagram.
The cable must not be bent or compressed.
Regularly check the power cord for damage. If the supply cord becomes damaged, it must be replaced by
the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.
WARNING: This is a Class I appliance and MUST be earthed.
The appliance is supplied with a 3-core mains cable and must be connected to the electricity supply via a
double pole switch having a 3 mm minimum contact gap on each connector.
Connect this appliance directly to the mains consumer unit using a 13 A Residual Current Device (RCD).
The wires in the mains lead are coloured in accordance with the following code:
Brown = L - Live
Blue = N - Neutral
Green and Yellow =
To avoid the risks that are always present when you use an electrical appliance it is important that this
appliance is installed correctly and that you read the safety instructions carefully to avoid misuse and
hazards. Please keep this instruction booklet for future reference and pass it on to any future owners.
After unpacking the appliance please check that it is not damaged. If in doubt, do not use the appliance but
contact Customer Services - see end of Care & Maintenance section for details.
211859_s1_s1-5059340158006-Single Fan Oven-C&L-IM-Easy-V01-Multi.indd 13 211859_s1_s1-5059340158006-Single Fan Oven-C&L-IM-Easy-V01-Multi.indd 13
- Earth
13
07-01-2021 12:41:26 07-01-2021 12:41:26