miniland baby ozonball Manual Del Usuario página 11

1
3 Fasten the water tank to the main body of the machine.
4 Check that the voltage is correct and that it coincides with the
voltage specified in this manual. Plug in.
5 Turn the machine on. When the light on the display comes on,
it will start to work.
6 Press the MAX / MIN button on the machine or on the remote
control, depending on the intensity that you require. This setting
will become automatic when a relative humidity is set.
7 Press the OZONE button so that this function starts to work.
A tree shape will appear on the LCD display. If you do not need this
function, press again and it will stop.
8 Constant humidity: Before you press the HUMIDITY button, the
present humidity level will show up on the display. The humidity
level must be maintained between 45% RH and 90% RH.
Press once and the humidity level will increase by 5% RH. When it
reaches the maximum (90% RH), press again and it will go back to
45% RH. After the desired humidity level has been determined, this
will automatically be stored in the memory. After a 5-second pause,
the display will show the present humidity level again.
If the humidity setting is less than the present humidity, the machine
will go on pause mode. However, if the expected humidity level is
higher than the present one, the humidification will work
automatically.
9 Time settings: There are 5 different time settings: 2,4,6,8 and
10 hours. Press the "TIMER" button. The display will show a clock
shape. The timer will show the remaining time and will decrease by
2 hours. For example, if the timer is programmed for 10 hours, the
display will show 8 after 2 hours.
10 Finally, if the deposit does not contain sufficient water, the machine
will not be able to continue functioning and will automatically stop.
There will be a brief beep during 10 seconds and then the icon
"insufficient water" will appear on the display. Unplug and fill the
water deposit up again, then turn the machine back on.
2
3 4
WATER