Chapter 17 - Emergency Situations; Chapter 18 - Faults / Causes / Remedies - Comet CSW 700 Manual Del Usuario

EN
- Instructions and operating manual CSW 700 B/G - CSW 900 B/G (translated from original instructions)
IIN ANY KIND OF EMERGENCY SITUATION SUCH AS, FOR EXAMPLE, IF YOU HAVE ACCIDENTALLY DRIVEN THE
SWEEPER OVER CURRENT-CARRYING CABLES ON THE FLOOR WHICH HAVE WOUND AROUND THE MAIN OR
SIDE BROOM, OR THERE ARE STRANGE NOISES COMING FROM INSIDE THE MACHINE OR MOTOR, OR YOU
HAVE ACCIDENTALLY PICKED UP INCANDESCENT MATERIALS OR FLAMMABLE LIQUIDS, CHEMICAL PRO-
DUCTS IN GENERAL, POISONS, ETC.
YOU WILL HAVE TO:
1. Release the lever to stop traction.
2. Turn engine off in the explosion engine models, putting the accelerator lever, that is on the engine, onto
OFF; or in the case of battery powered sweepers, turn the start key, on the control panel, from right to
left.
If you have collected any of the material described above, extract the container (bin) and clean it wearing
gloves and a mask to protect your lungs. In all events, please follow the instructions given on the paragraph
REFUSE CONTAINER.
Two main faults may occur in the CSW 700 – CSW 900 sweepers series: the machine causes dust during use
or leaves dirt on the floor; there can be many reasons for this but if the machine is used correctly and routine
maintenance is carried out regularly, they should not occur very often. Therefore:
FAULTS
The machine cause dust.
The machine leaves trace of dirt on the
floor.
The explosion engine is not performing
correctly.
The battery-powered sweeper is not
performing correctly; it is slow and is not
cleaning well.
CHAPTER 17 – EMERGENCY SITUATIONS
CHAPTER 18 – FAULTS / CAUSES / REMEDIES
CAUSES
Lever in position to stop suction (OFF).
Filter clogged.
Filter damaged.
Filter badly installed.
Side dust flaps damaged.
The main broom is not correctly adjusted or is
worn.
You have collected wires, cables etc.
Side flaps damaged.
The collection bin is full.
Engine air filter is dirty.
Carburation wrong.
Flat battery or not fully charged.
The battery charger is not the recommended
one or it is insufficient.
pag. 41
REMEDIES
Push the knob to open the suction (ON).
Clean them by shaking it with the filter-shaker
and if necessary remove and clean thoroughly.
Replace it.
Make sure is correctly inserted.
Replace them.
Check the main broom and it "track".
Remove them.
Replace them.
Empty it.
Clean or replace it.
Recarburate.
Check the level of the electrolyte and carry out
a new complete battery charging cycle.
Use an appropriate battery charger..