Dew Point - LaserLiner ThermoSpot-Vision Manual De Instrucciones

11
The corresponding display view is shown after selecting "IR measurement" or "dew point" mode. The
same measurement variables can be determined and displayed as in camera mode but without the live
image and recording option. The main difference between "IR measurement" and "dew point" modes is
the bargraph function at the bottom of the display.
IR measurement
12
The settings menu is shown in the display after selecting "DATALOG" mode. After setting the corresponding
parameters, data recording is started automatically by pressing the trigger. A real-time curve diagram is shown
on the display. Stop recording by pressing the "ESC" button and return to the Settings menu. The data
recording is saved automatically.
IR measurement / dew point

Dew point

Datalog
High
Low
Time
Colour
Measure set
Set upper temperature limit (red line)
Temperature curve (selectable line colour)
Set lower temperature limit (green line)
Currently measured temperature
ThermoSpot-Vision
IR measurement bargraph:
shows the measuring range of the current
measurement within the Min/Max range.
Dew point bargraph:
shows the percentage probability of condensation
on the surface. The condensation probability is 100
% as soon as the surface temperature is equal to or
lower than the dew point temperature.
Set upper temperature limit
Set lower temperature limit
Set measuring time (1 second to 3600 seconds)
Set colour of temperature curve
Settings for measuring mode (see Point 8)
GB 17