Assembly Instructions - Grizzly ELS 2801 Profi Traducción Del Manual De Instrucciones Original

GB
ground.To protect the user, the appli-
ance can only be used with the blow-
ing/suction pipe completely installed.
The appliance is double-insulated, and
does not need to be earthed.
Refer to the following descriptions for in-
structions on how the operating controls
work.

Assembly instructions

Remove the power plug before all
work on the device. Employ only
original parts. Danger of injury.
Unpacking:
Unpack the device and check whether it is
complete:
5 Leaf blower motor part
A
2 Two-part blower/vacuum tube
18 Collection bag with bag holder nozzle
22 Flat nozzle
1 Carrying strap
3 + 4 Assembly material
Before putting the device into op-
eration, the blower / suction tube
must be completely mounted and
screwed tight and the collection
bag and carrying strap must be at-
tached. The impeller wheel cover
must be closed and the attachment
screws must be tightened all the
way.
Mounting of blower / suction tube:
Make sure the tubes are held
straight during mounting. The elec-
trical contacts in the tube could be
damaged.
B
1. Connect the two parts of the
blower / suction tube (2a + 2b).
128
The two parts of the tube engage,
whereupon they cannot be disen-
gaged for safety reasons.
2. Fasten down the tube sections
using the smaller enclosed
screws (3).
3. Insert the blower / suction tube
into the blower / suction open-
ing on the motor component (5).
Use the guide rail on the motor
component as an aid.
4. Fasten down the tube and motor
component using the larger en-
closed bolts and nuts (4).
Mount flat suction nozzle:
5. To work with the flat suction nozzle
(22), push it onto the suction opening
(23) on the tube until the lateral clips
engage.
To remove the nozzle, pull the clips on
the nozzle apart and pull the nozzle
out of the tube.
Mount collection bag:
6. Place the retainer frame (17) onto the
opening on the motor components
(5) so that the grip points towards the
mains cable. Press the retainer frame
over the engagement strip until the
coupling lever engages.
Suction operation is only per-
missible with the collection bag
mounted.
7. Connect the collection bag retainer
loop (19) to the blower / suction tube.
Mount carrying strap:
8. Hook the carrying strap (1) onto the
attachment bar (8).