Operation; Initial Operation - Grizzly ELS 2801 Profi Traducción Del Manual De Instrucciones Original

Operation

Danger of injury.
Wear suitable clothing and
work gloves when working with
the device. Make sure that the
device is functioning properly
before every use. Make sure that
the collection bag and the tube
are assembled correctly and
the carrying strap is adjusted
correctly for work. If a switch
should be damaged, work with
the device must not be carried
out any longer. Make sure that the
mains voltage values are compat-
ible with the label on the device.
Note noise protection laws and lo-
cal regulations. The use of the de-
vice can be restricted or prohibited
on certain days (e.g. Sundays and
holidays), during certain times of
the day (lunch hours, at night) or in
special areas (e.g. health resorts,
clinics etc. ).
After switching off the device,
the impeller wheel continues to
rotate for some time. Danger of
injury due to rotating tool.

Initial Operation

Before switching on device, make
sure it is not in contact with any
objects. Ensure stable positioning.
The device can only be switched
on if the entire blower / suction tube
is correctly mounted. The impeller
wheel cover must be closed and the
attachment screws must be tight-
ened.
C
1. Make a loop of the end of the ex-
tension cord and fasten this to the
cable support (15). By means of
this tension relief, an unintentional
pull-out of the electrical plug con-
nection is avoided.
2. Put on the carrying strap (1) and
adjust it to the optimum length.
3. Open the quick-release fastener
(7) and move the additional grip
(6) to the desired position. Re-
close the quick-release fastener.
4. Make sure that the device is
switched off and connect the de-
vice to the mains voltage.
5. In order to select the operation
mode, turn the operation mode
selector (16) to the symbol re-
quired.
Before changing the operat-
ing mode, it is absolutely
necessary that the device be
switched off.
Blowing operating mode
Suction operating mode
6. For switch-on, slide the on/off
switch (9) into position "l", the
device starts up.
To switch off, slide the on/off
switch (9) into position "0", the
device switches off.
7. With the airstream regulator
(10) set the optimal blowing and
sucking strength.
8. During operation, hold the device
with one hand on the casing grip
and the other on the additional
grip. Grip the handles inside of
the vibration-dampened areas
fitted with vibration dampers (
26).
GB
A
129