Morphy Richards TURBOSTEAM 40659 Manual De Instrucciones página 5

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 20
The shot-of-steam can be used
whilst dry ironing, providing there is
water in the tank, and the
temperature control is set within the
steam range.
Do not use shot-of-steam at
temperatures below the steam
range shown on the control dial.
For optimum steam quality, do not
operate the shot more than three
times in succession.
Vertical steam
Hold the iron in a vertical position
between 1cm and 2cm away from
the item C. Press the shot-of-
steam button, this will create
vertical steam.
This feature is especially useful for
removing creases from hanging
clothes, curtains, wall hangings, etc.
For optimum steam quality, do not
operate the shot more than three
times in succession.
Spray
Press the spray button ¤ and aim
the spray of water at stubborn
creases. You can do this whilst dry
ironing providing there is water in
the tank. When using the water
spray it may be necessary to push
the button a few times to get the
spray pump primed.
No drip system
(certain models only)
Your iron is fitted with a no-drip
system which is designed to
prevent water escaping from the
soleplate when the iron is too cold.
During use, the no-drip system may
emit a loud click, particularly during
heat-up or whilst cooling down. This
is perfectly normal and indicates
that the system is functioning
correctly.
Auto shut-off
(certain models only)
If the iron is fitted with the auto
shut-off function it will automatically
shut down after a set period.
If the iron is left unattended in the
horizontal position it will shut down
after 30 seconds.
If it is left in the vertical position it
will shut down after 8 minutes.
When this happens the two 'power
on' lights, located in the back cover
will flash to show that the iron is in
power-off mode.
To reactivate the iron gently shake it
until the 'power on' lights stop
flashing and remain on.
The iron will then start to heat back
up to the temperature it is set to.
Life long anti-scale
system
(certain models only)
The life long anti-scale system
reduces scale deposits and helps
prolong the life of the iron.
Emptying and storing
When you have finished ironing,
unplug your iron. Ensure that the
variable steam control is set at the
'O' position, lift up the fill cap and
empty any remaining water out of
the filling hole.
Do not store in the box, but in an
upright position, so that any drops
of water remaining cannot leak out
and discolour the soleplate.
IMPORTANT: The flex can be
damaged if wound too tightly
around the iron after use. Make a
loose loop with the flex and wrap it
around the iron. The iron must be
cool before winding the flex and
storing on its heel.
CLEANING
Jet cleaning
Your iron has a built-in cleaning
system designed to keep the water
valve, steam chamber and steam
vents clear of lint and loose mineral
deposits. Jet clean should be used
after each period of ironing.
1
Ensuring that there is a little water in
the tank, place the iron on its heel
and turn the temperature control
dial to the maximum setting.
D
g
5

Publicidad

Tabla de contenido
loading

Tabla de contenido